Can I hook up a subwoofer to my receiver?

Let’s find an answer to "Can I hook up a subwoofer to my receiver?". The most accurate or helpful solution is served by eHow old.

There are ten answers to this question.

Best solution

Answer:

Adding a subwoofer to a home theater setup will enhance the audio presentation of movies and television...

Read more

Eric Barnes at eHow old Mark as irrelevant Undo

Other solutions

Is there a way i can hook up a subwoofer to my receiver?

my receiver has one of those subwoofer outputs that you hook an amp up to(its like an RCA output) i dont have an amp but is there a way that i could hook one up? like get an RCA cable and cut the other end off and hook it up to my subwoofer? i know that...

Answer:

Is your sub passive? More than likely you have a issue with the down mix in your receiver and need to...

Read more

rjs8991 at Yahoo! Answers Mark as irrelevant Undo

Can i hook up a subwoofer to my basic Sony stereo receiver?

the subwoofer on the back has a subwoofer slot, and rca slot (red and white).. it does not have any speaker wire cable slots my receiver has rca slots, and multiple speaker wire slots (fronts, rears, center), but no dedicated subwoofer slot I had to...

Answer:

Give brand and model of both your receiver and subwoofer.

Read more

kevin45 at Yahoo! Answers Mark as irrelevant Undo

Can i hook up a powered subwoofer to a non powered receiver?

Hello my surround reciever has a subwoofer output for a non powered subwoofer. would i still be able to connect a powered subwoofer thru this output? or could i use the analog audio ...show more

Answer:

you can hook up a powered subwoofer to just about anything almost all powered subwoofers have 2 sets...

Read more

Q3DL46KDVIZIRZBVG2ICLMNMGY at Yahoo! Answers Mark as irrelevant Undo

How can I hook up my subwoofer to my receiver?

I have an mtx sub with an input for speaker wire but my receiver only has an input for a subwoofer jack. http://www.circuitcity.com/ssm/Sony-STR-DG710-6-1-Channel-Home-Theater-Receiver-STR-DG710/sem/rpsm/oid/179236/catOid/-12949/rpem/ccd/productDetail...

Answer:

Your receiver's sub output is not amplified meaning that the signal being sent out from the sub out...

Read more

jmaser at Yahoo! Answers Mark as irrelevant Undo

How can I hook up my subwoofer wen my receiver has no inputs for it?

Hi I have a Sony model str-d360z and a Panasonic sb-as250 power active subwoofer but my receiver has no inputs for it what should I do

Answer:

No receiver has an, "input" for a subwoofer. The subwoofer does not send information to the...

Read more

Liviu at Yahoo! Answers Mark as irrelevant Undo

Answer:

Yes the subwoofer is "powered" so it will connect to the subwoofer preamp output. Also just...

Read more

Joseph at Yahoo! Answers Mark as irrelevant Undo

How to hook up subwoofer to Denon receiver?

I purchased a Pioneer - 8" 100-Watt Powered Subwoofer SW-8 today from best buy and told them i had just bought a Denon AVR-791, he told me to buy basic red and white cables and plug them into the subwoofer and plug the other end into the any of...

Answer:

Denon's website indicates that this reciever has a sub-pre-out put but the picture is so bad that I...

Read more

Water Traveller at Yahoo! Answers Mark as irrelevant Undo

How to hook up an unpowered subwoofer to a receiver that only accepts an rca jack?

I currently have a Sony STR-DE698 receiver that has three speakers hooked up to it. A friend recently gave me his old unpowered sub which is a Sony SS-WMSP66. So my question is, how can I hook up the sub to the receiver if the receiver has an RCA jack...

Answer:

You are correct, you must buy an amp or get a new sub. You can find a subwoofer amplifier here... http...

Read more

bballcrazy2234 at Yahoo! Answers Mark as irrelevant Undo

What cable do I need to hook up my subwoofer to AV receiver?

I have a Denon 1912 AVR with a "Subwoofer pre-out" and an Energy RC-Micro subwoofer with a "Line in / Sub In" which are 2 ports (left is white and right is red). What cable do I need to connect the sub to the receiver? Thanks!

Answer:

RocketFish 4' HDMI Cable (RF-G1111) 95% copper braid and dual layer 100% aluminum Mylar foil shields...

Read more

jed at Yahoo! Answers Mark as irrelevant Undo

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.