How do i wire my stereo?
Let’s learn how do i wire my stereo. The most accurate or helpful solution is served by Yahoo! Answers.
There are ten answers to this question.
Best solution
I have an 89 toyota pickup and the aftermarket stereo was stolen. The wire harness was removed during the theft so only the stock bare wires are in the car. I dont want to pay for an installation because I know how to install it, I just dont know how...
Nick B at Yahoo! Answers Mark as irrelevant Undo
Other solutions
I just got a 1992 Subaru Legacy. The stereo worked fine, but I upgraded the deck so that I could use Aux input. The car was rewired, and the harness was bypassed. I have everything working except the constant wire. My Stereo has to restart itself everytime...
Answer:
Use a volt meter or a test light. With the key off, see which one reads 12V or lights the light with...
Tom at Yahoo! Answers Mark as irrelevant Undo
I have a JVC receiver and I bought a wire harness to adapt my truck wire harness to the receiver. I need to wire it so it will turn off when I turn my truck off. Now it will work but I don't want to run my battery down. And when I turn it on the sound...
Answer:
the problem is that you have the wrong wiring harness, that is the reason why this kits exist http:...
Alex at Yahoo! Answers Mark as irrelevant Undo
Right now, my new aftermarket car stereo turns off as soon as I turn the key to "off". My previous aftermarket stereo didn't turn off right away, it waited until i opened the door or until a certain amount of time passed. How can i reconnect...
Answer:
that feature depends on the car usually... it has to do with the way the car's electronic system is...
chog at Yahoo! Answers Mark as irrelevant Undo
i have a zx750.1 amp.. one channel amp at 2 ohms it has 750 watts. at 4 ohms it has 375.. i have 2 twelve kicker compvr it is either 2 or 4 ohms. but i have two and either way i wire it , i end up with 4 ohms.. if i have one sub i can wire it to 2 ohms...
Answer:
im not sure you can run a 1 channel amp at two ohms because you need two channels to bridge? with two...
Morgan at Yahoo! Answers Mark as irrelevant Undo
i have a 1993 mazda 626 es and i am switching out my stock stereo. removing the stock one was very tricky, but i got it done. i plugged in my antenea and new wiring harness into the new radio(it is a cheap Dual), but there is no slot for the amp, and...
Jesse at Yahoo! Answers Mark as irrelevant Undo
I had someone steal my stereo out of my truck and now i cant get the new one to work correctly and I think that it is my constant wire that is burned out so I need to know how to replace it, I tried running directly from the battery and it gave me problems...
Answer:
well if the constant power wire is bad replace it...it runs from the radio fuse to the radio......not...
mc_dugen at Yahoo! Answers Mark as irrelevant Undo
I want to play my television's sound through my stereo. To do this, I was told I needed an RCA stereo cable to connect the two. One end of this cable was supposed to go into ...show more
Answer:
what i did was get a connecter thing it has a red and white cord on one side and just a ear phone piece...
EACSL46UPRJIO3YS5C4SPRLWKA at Yahoo! Answers Mark as irrelevant Undo
My stereo wont play a dvd unless i hook up the parking brake wire.It says "The pink wire must be connected to the switched side of the parking brake circuit (the part that becomes ...show more
Answer:
http://www.DIYBypass.com sells the bypass for all of the new radios that require double pulses on the...
TYQPX4YMWQHHIJVEGQWWQH3GXI at Yahoo! Answers Mark as irrelevant Undo
So i got a stereo for my birthday and i went to walmart to get the wireing kit. it said i have the right kit 1970 -2000 mustang. i brought it home set it up and the stereo turned on but the speakers didnt. in The box the wiring came in there were two...
Answer:
because you must have a factory amplifier some were.the speakers are hooked to this.find the remote...
Cameron at Yahoo! Answers Mark as irrelevant Undo
Related Q & A:
- How do I wire 2 amps properly?Best solution by Yahoo! Answers
- How do I wire to Rockford subs?Best solution by Yahoo! Answers
- How do I wire this amp/sub up?Best solution by Yahoo! Answers
- How would I wire subs to AMP?Best solution by Yahoo! Answers
- How do I wire up two separate amps in my car?Best solution by Yahoo! Answers
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.