How should I connect my line-level amp?
Let’s learn how should I connect my line-level amp. The most accurate or helpful solution is served by Yahoo! Answers.
There are ten answers to this question.
Best solution
Do I pull the stock speaker wires out of my rear speakers and wire them into the amp? A little confused on what to do. Thanks!
Answer:
Just connect the speakers wire coming from the head unit to the high level input to the amp. Then get...
Tibs99 at Yahoo! Answers Mark as irrelevant Undo
Other solutions
Hi, I'm very new to this. And I'm trying to setup a karaoke system for my dad. I recently bought: 1. Yamaha MG166CX 16-Channel 6-Bus Analog Mixer http://i.imgur.com/ZXRUq.jpg 2. PA DJ Karaoke Home Pro Audio 15" Three Way Black Speaker Pair 1500C...
Answer:
To go from the mixer to the amp... don't use the cables you have specified. Speaker cables are designed...
Giot Nuoc at Yahoo! Answers Mark as irrelevant Undo
My car audio player is integrated, I cannot open amp board and take pre amp out to connect my subwoofer which is having inbuilt amplifier. I need a circuit which will interconnect only amp output to another amp input.
Answer:
Don't understand your question. When you say integrated, do you mean factory stereo. model number of...
Srinivas D at Yahoo! Answers Mark as irrelevant Undo
Hey, I would like to connect speakers to my amp. However, after searching the internet for a little while, I found out I probably need speaker openings on my amp, and my 35 watt amp doesn't have these speaker openings. The only jack openings my amp has...
Answer:
Unfortunately you will not be able to put an extention speaker on that particluar amp. The amp itself...
Sam at Yahoo! Answers Mark as irrelevant Undo
I am running a 4 ohm dvc now, each coil to its own +- terminal on the amp. That as i understand gives 2 ohm load for the amp. What happens if i connect the 4 ohm sub in parallel, and then connect instead to just 1+1- of the terminals, and leave out ...
Answer:
the results are the same. Scenario 1 makes the parallel connection at the amp. Scenario 2 makes the...
kaeksen at Yahoo! Answers Mark as irrelevant Undo
I have a Clarion XMD1 head unit on my boat right now. I just bought a CMD6 head unit since my old one was having problems. I was thinking of switching the boat speakers from the amp to the new head unit to take some heat off my Panasonic amp. I have...
Answer:
you would get much cleaner sound running the speakers off an amp, especially if the power output matches...
Jason A at Yahoo! Answers Mark as irrelevant Undo
So I want to connect a aftermarket amp & subwoofer. I was thinking of buying a Hi/Low Adapter so I can connect the RCA's from my new amp to my factory stereo which has a factory amp to all the speakers but I was wondering if I do that will my factory...
Answer:
you'll be fine, just dont mess with any of the factory amplifier settings. just splice the hi/low converter...
a.n. at Yahoo! Answers Mark as irrelevant Undo
I currently have 2 cerwin vega's hooked up to my yamaha integrated amp ( au-900 ) and I just bought 1 mackie thump 15'. The guy at the music store told me I could connect the Mackie to the headphone jack on the integrated amp. However, the Mackie makes...
Answer:
You've already asked this before, and received correct answers. How many different Y!A accounts do you...
Chittend... at Yahoo! Answers Mark as irrelevant Undo
i have 2 12 inch pioneer subs i want to connect to the ssl amp and 2 12 inch sundown e-series i want to connect to the hifonics amp. can i connect the 2 amps together? i also have 0 gauge power and ground wires.
Answer:
No you can't run amps in series or parallel configuration. That's a lot of power, what battery's and...
guitarturtle at Ask.com old Mark as irrelevant Undo
So like the title suggests I want to connect my Toshiba Satellite to my HDTV for picture for which I have a HDMI cable and I want the sound to come out of the amp that I have. For the sound I have the cable that on one end is the red and white jacks...
English Boi at Yahoo! Answers Mark as irrelevant Undo
Related Q & A:
- How do i reset low ink level alert on dell 924 printer?Best solution by Yahoo! Answers
- How can I get a line cook job at Olive Garden?Best solution by Yahoo! Answers
- How do I connect an equalizer to a receiver that has no tape monitor, or pre amp in and out?Best solution by wikihow.com
- How do I replace the line on my Zebco spincast reel?Best solution by Yahoo! Answers
- How should I connect my wires to my amp?Best solution by Yahoo! Answers
Just Added Q & A:
- How many active mobile subscribers are there in China?Best solution by Quora
- How to find the right vacation?Best solution by bookit.com
- How To Make Your Own Primer?Best solution by thekrazycouponlady.com
- How do you get the domain & range?Best solution by ChaCha
- How do you open pop up blockers?Best solution by Yahoo! Answers
For every problem there is a solution! Proved by Solucija.
-
Got an issue and looking for advice?
-
Ask Solucija to search every corner of the Web for help.
-
Get workable solutions and helpful tips in a moment.
Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.