How to replace blower motor resistor on a Nissan Sentra?

Let’s learn how to replace blower motor resistor on a Nissan Sentra. The most accurate or helpful solution is served by Yahoo! Answers.

There are ten answers to this question.

Best solution

Step by step instrutions on how to replace blower motor resistor on a nissan sentra?

pictures would be nice and\or step by step instruction thanks alot

Answer:

Under the glove box,near the firewall,mounted on housing of heater box,unplug harness,use a stubby philip...

Read more

mike m at Yahoo! Answers Mark as irrelevant Undo

Other solutions

Answer:

Answer Check to see if you have 12 volts at the blower motor. If yes then the blower motor is bad....

Read more

community wiki at wiki.answers.com Mark as irrelevant Undo

'02 Nissan Sentra Heat & A/C only blow on 4 NOT BLOWER MOTOR RESISTOR?

So this problem has been going on for a while now and I just got around to picking up a resistor because that's what everyone says it should be. When I snapped the wiring into the new resistor and tested it, I still get the same problem; the A/C and...

Answer:

Check the resistance at the blower motor when you change the speed on the knob. If you get infinite...

Read more

David at Yahoo! Answers Mark as irrelevant Undo

Can a failed blower motor resistor, on a 2001 Nissan Sentra, impact the high speed setting?

Only the high speed setting, on the HVAC blower, has been operative for a good while. Now, blower output is weak and labored on the high speed setting. The lower speed settings continue to be totally inoperative.

Answer:

A bad blower motor with High Amp draw will burn out the resistor and melt the switch too. Replace both...

Read more

Larry at Yahoo! Answers Mark as irrelevant Undo

How do you go about to replace a blower motor on a 2005 Nissan Sentra? Do you go from the top, bottom,where?

The motor is cheap enough about $35,but the shops want near $400 to do so. I suspect the brushes wore out as it came back on after you hit a bump, but will not last too much longer after that. I have tools enough but do not know where to begin dis-assembly...

Answer:

Phillips screwdriver is about all it takes remove the glove box and right behind is the blower case...

Read more

Virgil at Yahoo! Answers Mark as irrelevant Undo

Answer:

Under the dash on the passenger side. There are two screws to remove it, and the replacement goes right...

Read more

wiki.answers.com Mark as irrelevant Undo

Answer:

I just had to replace mine today after my fan crapped out 2 weeks ago (also only had super high speed...

Read more

wiki.answers.com Mark as irrelevant Undo

Answer:

The 2002 Nissan Sentra blower motor resistor is located near the blower motor itself, wich can be found...

Read more

community wiki at wiki.answers.com Mark as irrelevant Undo

Answer:

The fan will always have power under normal conditions when on. The speeds are controlled by the resistor...

Read more

wiki.answers.com Mark as irrelevant Undo

Answer:

In a 98 Nissan Sentra GXE the blower motor resistor is located at the passenger side, right side at...

Read more

Anonymous at ChaCha Mark as irrelevant Undo

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.