Subs and Amp for a car?

Let’s learn subs and Amp for a car. The most accurate or helpful solution is served by Yahoo! Answers.

There are ten answers to this question.

Best solution

Suggestions for car subs / amp ?

I am looking to add subs / amp to my car . I am currently looking at two 12 inch dual subs with a 2000 watt Pyle amp . What do you think about these ? and what are your suggestions on subs i should get ? Moneys not a huge issue but they need to be in reason .

Answer:

I'd really recommend a little more research before you part with your cash, especially for the Pyle...

Read more

Konnor at Yahoo! Answers Mark as irrelevant Undo

Other solutions

How to hook up an amp and subs to a deck and only play bass through the subs but not in-car speakers?

So I recently hooked up my two 12 inch Kicker subs with my Rocksford Fosgate Amp into a new Kenwood deck in my car. Everything works fine, but its not the same as when I had somebody else hook up the system on my last car. I noticed that my in-car 6x...

Answer:

i always have at least 2 amps for my highs and lows, this prevents speaker damage

Read more

Dallas at Yahoo! Answers Mark as irrelevant Undo

I need Help with My car audio Setup .. 3 subs 1 amp . I need to wire them correctly?

Alright well I have a 4 ohm Kicker CVR and TWO 2 ohm Kicker CVX's in a huge box that looks like a volcano for three 12 inch subs. Now I have a Hifonics brutus 2610 and I want to wire it all at 2 ohms. Is it ok to do this because one of the subs is 4...

Answer:

I'm pretty sure each sub is DVC (dual voice coil) as my research showed. First, your amp is going to...

Read more

Brandon at Yahoo! Answers Mark as irrelevant Undo

Car amp turns on but subs don't go?

So long story short I had my subs in and working brother took them out now I went to put then back in I hooked up the positive and negative and now the amp turns on but seems to not be powering the subs. I sorta have the ground wire screwed into the...

Answer:

did ya connect the remote turn on wire

Read more

winterle... at Yahoo! Answers Mark as irrelevant Undo

Car amp isn't powering subs?

I have a kac-9104D kenwood amp hooked up to 2 12" jl w6's. I have had then hooked up before then took them out for about 2 weeks and now I'm putting them back in. All I did was take the subs out not the wiring or amp that has been just sitting in...

Answer:

if it worked before it will work again unless dampness got into the amplifier from sitting,i would clean...

Read more

winterle... at Yahoo! Answers Mark as irrelevant Undo

Sub and amp help car audio i.c.e bad sound quality from subs?

ok i have a eq pionner front out back out sub out the ft bk go into a hifonics zeus amp mids only sub goes in to my d5000 amp then chains from the out into my other d5000 amp amp 1 are on master amp 2 on slave and turned all gains down i had a large...

Answer:

If your speakers are moving alot (like when you look at them your thinking to yourself, these should...

Read more

mark.cro... at Yahoo! Answers Mark as irrelevant Undo

I need help on hot to wire my subs in my car, i have 2 subs and a mono amp?

i have 2 bazooka pmiller series subs that are 4 ohms, and a 850 watt amp that is single channel, how should i wire these? i wired them this way and my amp turns off it i turn it up to loud, the speakers have 2 negatver terminals and 2 possitive terminals...

Answer:

To much load on your amp.When you hook them up like that you drop the ohms on the amp.You need to see...

Read more

brandonr... at Yahoo! Answers Mark as irrelevant Undo

Car audio. Want to make sure I hooked up my subs correctly to my mono amp.?

I bought 2 10" Memphis dual voice coil subs. I bought a Memphis 600x1 mono amp for them. This is how I hooked it all up. Amp has two spots to hook wires (like channels). I chose one. Used a one pair wire from one channel to one sub box hook up location...

Answer:

http://www.the12volt.com/caraudio/boxcal… this may help, this site has a massive amount of info...

Read more

alex at Yahoo! Answers Mark as irrelevant Undo

Can you run two subs off a mono amp? - car audio?

I'm thinking about getting a new amp for my car audio system (powering 1 12 inch Sony xplod 1200 watt max 450 RMS) and I was wondering if you can use a Monoblock amp to run two subs? Is it possible to bridge two subs into a mono block amp? If so, I take...

Answer:

You can run 50 subs if the impedance is right. Find the output impedance of the amp, the impedance of...

Read more

Nomadd at Yahoo! Answers Mark as irrelevant Undo

Car subs two type r subs with p1000 amp or 1 boston spg with t1000 amp?

What is louder 2 12 type r in a chevorlet trail blazzer with a p1000 amp or 1 boston spg with a t1000 amp in a lincon continental only answer question if u know about subs ps. My friend has the type r and im about to get the boston spg

Answer:

Most likely the two type R's, more cone area. But a lot of other things come into play.

Read more

derek smith at Yahoo! Answers Mark as irrelevant Undo

Related Q & A:

Just Added Q & A:

Find solution

For every problem there is a solution! Proved by Solucija.

  • Got an issue and looking for advice?

  • Ask Solucija to search every corner of the Web for help.

  • Get workable solutions and helpful tips in a moment.

Just ask Solucija about an issue you face and immediately get a list of ready solutions, answers and tips from other Internet users. We always provide the most suitable and complete answer to your question at the top, along with a few good alternatives below.