Who can install a turbo in the dallas area?

When I write the following code in Turbo Pascal 7.0, it compiles successfully. But when I run the program, I get the message Error 200: Division by zero. Program areaandperimeter(input,output); Uses CRT; Var length:integer; width:integer; area:integer...

I have an 03 RSX Type S, and like I said I bought a Garrett T3/T4 50trim Turbo. Right now my current mods are a GReddy Ti-C catback exhaust, and a AEM Short Ram Intake. I know I will have to get rid of my intake. What else will I need to install? I know...

i have a 94 dodge shadow 2.5L 4 cylinder engine. and i am looking to put a turbo on it and a friend said to look into a 2.2L engine of a shadow... is it possible to take the manifolds and turbo off the 2.2L and install it on a 2.5L.... if not what is...

Does anyone know of shops in Central Jersey preferably, or the tri-state area where they install turbos? Also, the approximate cost.

I want to create a "radiant barrier" and tack aluminum sheeting to the bottom of my roof rafters. I have no interest in additional insulation or a floor roll. So far quotes range from $1800 and up for a 2000 sq. ft. home.

I have done all of the other major mods to my Expedition except the headers and before I buy them, just want to make sure or ask what a good quote is to install them? I am in the Dallas/Ft. Worth area, and have no mechanic that I routinely go to. Any...

I BOUGHT THIS CAR IN APRIL.... I WRECKEDC THE FRONT END 3 DAYS LATER I FIXD EVERYTHING N NOW THERES SOMETHING WRONG WITH IT I CHANGED MY ALTERNATOR AND MY BATTERY IT HAD A SHORTAGE AND IT TOO WAS FIXED... NOW MY CAR WONT HOLD A CHARGE AT ALL IF U KNO...